Bedford CF-UK Message Board Logo [Home] [Search] [FAQ]
Bedford CF-UK Message Board > CF Questions > master cylinder
[Private Message] [Register] [Profile] [Member list] [Log-in]
Who's Online:
There are 0 member(s), and 1 guest(s) online.
 
[Printable Version] [Post Reply]
Author Message
Anon
Deleted
Posts :
Location :
Status    : Offline

master cylinder

Is the master cylinder supposed t be sealed to the servo?
The bolts are tight and the cylinder is flush but there is a gap either side.
There is no mention of a gasket in the manual but I think it looks wrong.
Should I try and seal it?

Steve

----------------------

Wed 11 Sep 2013 @ 12:04 Edit this messageQuote this messagePMQuote this message
Gethin
Card Holder
Posts : 462
Location : east lancs
Status    : Offline

there should be a rubber seal between the master cylinder and servo body..........
Wed 11 Sep 2013 @ 19:47 View Gethin   Email Gethin   Edit this messageQuote this messagePMQuote this message
Anon
Deleted
Posts :
Location :
Status    : Offline

Thanks Gethin, it has the rubber seal on the end of the cylinder. Is that the only one?
Wed 11 Sep 2013 @ 20:37 Edit this messageQuote this messagePMQuote this message
Gethin
Card Holder
Posts : 462
Location : east lancs
Status    : Offline

yes
Wed 11 Sep 2013 @ 21:31 View Gethin   Email Gethin   Edit this messageQuote this messagePMQuote this message
Time in GMT
[Post Reply]
New posts since your last visit Administrative Functions: Open/Close/Delete Thread / Move Thread
Old post

Forum Jump:

Back to the CF-UK Homepage ][ Email CF-UK

Powered by FunkBoard vCF0.74c