![]() |
[Home] [Search] [FAQ] |
---|---|
[Private Message] [Register] [Profile] [Member list] [Log-in] |
Who's Online: |
There are 0 member(s), and 1 guest(s) online. |
[Printable Version] [Post Reply] |
Author | Message |
---|---|
Anon Deleted Posts : Location : Status : Offline |
gearbox I am in the process of fitting a new gearbox to my cf on the box I am taking out their is a place to connect two wires on the plate that the gear stick goes into on the new box it is blank can I just swap the plates round and I need a seal for were the speedo cable goes in any one know were I can get one thanks |
![]() | ![]() ![]() ![]() |
bluebedouin Global Moderator Posts : 2444 Location : Northampton,England. Status : Offline ![]() |
Could you put up a pic of the old seal?I have a box of bits & bobs that might have one in but I need to know what I'm looking for. ---------------------- |
![]() |
![]() ![]() ![]() ![]() ![]() |
Anon Deleted Posts : Location : Status : Offline |
there is a picture of the seal in the file downloads group 8 at the speedometer section it a small seal with a spring over it |
![]() | ![]() ![]() ![]() |
Anon Deleted Posts : Location : Status : Offline |
Cover plate. Hi Joe,I think you are just talking about the cover plate on the gearstick turret, if so then you can just swap them over, you must have a reverse light switch fitted to your own one, the plate is just held on by two 7/16 AF studs. doujoy ---------------------- |
![]() | ![]() ![]() ![]() |
Anon Deleted Posts : Location : Status : Offline |
yes I think that's what the wires do any seals needed on the plate |
![]() | ![]() ![]() ![]() |
Anon Deleted Posts : Location : Status : Offline |
yes I think that's what the wires do any seals needed on the plate |
![]() | ![]() ![]() ![]() |
Anon Deleted Posts : Location : Status : Offline |
Cover plate. Hi Joe,There is a seal behind that gearstick turret so no need for a seal under the cover plate but before you fit the plate make sure there is plenty of grease inside the casing to keep the selector shaft and finger lubricated and keep the water out. doujoy ---------------------- |
![]() | ![]() ![]() ![]() |
Anon Deleted Posts : Location : Status : Offline |
thanks doujoy know anywhere I could get the o ring seal for the speedo cable |
![]() | ![]() ![]() ![]() |
Anon Deleted Posts : Location : Status : Offline |
O- ring. Hi Joe,I buy a box of mixed O-rings from a motor factors for about ten pounds which has every size and thickness of O-ring you could need. doujoy ---------------------- |
![]() | ![]() ![]() ![]() |
Anon Deleted Posts : Location : Status : Offline |
I need the nut that screws down to hold the gearstick lever in the gearbox the one I have the gear lever just pushes in to it the new box needs the nut |
![]() | ![]() ![]() ![]() |
Time in GMT |
[Post Reply] | |
![]() |
Administrative Functions: Open/Close/Delete Thread / Move Thread |
![]() |
Back to the CF-UK Homepage ][ Email CF-UK
Powered by FunkBoard vCF0.74c