Anon
Deleted
Posts :
Location :
Status : Offline
|
Engine mounts.
Hi Norman.
If you take a look at the mounts they are sided they must go on the correct side of the engine, the threaded pins are off set and there is a locating pin which most engage to put the mount in the correct position.
Because of the angle they sit at they are best left loose until they are through the slotted holes in the cross-member brackets, once you get the driver-side one into place the passenger-side one will be sitting on its pin use a piece of strong cord to tug it into place (saves on fingers).
doujoy
----------------------
|
New posts since your last visit
Old post
